All articles
How-toOctober 20, 2026·1 min read·By PoolWaterFountain Team

Does a Pool Waterfall Need Its Own Pump?

Whether your existing pool pump can run a waterfall depends on its width and height. Here is a simple way to check before you buy.

This is one of the most common questions we get at PoolWaterFountain.com, and the honest answer is: it depends on the size of the waterfall.

Small features usually run on your existing pump. A scupper, a deck jet, or a sheer descent up to about 2 feet wide can typically be fed from a pool return line using a diverter or valve. You give up a little return flow to the pool, but most filtration systems handle that without trouble.

Wide features usually need a dedicated pump. A good starting point is about 15 gallons per minute for each foot of sheer descent, and 20 to 25 gallons per minute per foot for a rain curtain. A 4 foot sheer descent can need around 60 GPM on its own, which is often more than a filter pump can spare while still cleaning the pool.

Height matters too. The higher the waterfall sits above the water, the more the pump has to push. Features mounted 12 to 36 inches above the waterline are typical.

A quick check you can do: find your pump's model label and look up its flow rate. Compare it with the waterfall's required flow. If the waterfall would take more than about a third of the pump's capacity, plan for a separate pump with its own valve or timer.

Variable-speed pumps are a great fit for waterfalls because you can turn the flow up for a show and down for quiet evenings, while saving energy.

Not sure? Use our Waterfall Size Guide, or send us a message from the Contact page with your pump model and pool size and we will help you choose. Every waterfall at PoolWaterFountain.com ships anywhere in the USA, ready for you or your pool guy to install.

Share:P

Ready to pick your waterfall?

Shop pool waterfalls